Arduino + temperature sensor ds18b20

Digital temperature sensor ds18b20 should be connected to the Arduino via a resistor 4.7 k (Figure 1).

arduino+ds18b20
Figure 1 – Wiring ds18b20 sensor to Arduino

Let’s write a program to Arduino, which will read the temperature and sent to the computer display.

#include

int DS18S20_Pin = 2; //DS18S20 Signal pin on digital 2

//Temperature chip i/o
OneWire ds(DS18S20_Pin); // on digital pin 2

void setup(void) {
Serial.begin(9600);
}

void loop(void) {
float temperature = getTemp();
Serial.println(temperature);

delay(100); //just here to slow down the output so it is easier to read

}

float getTemp(){
//returns the temperature from one DS18S20 in DEG Celsius

byte data[12];
byte addr[8];

if ( !ds.search(addr)) {
//no more sensors on chain, reset search
ds.reset_search();
return -1000;
}

if ( OneWire::crc8( addr, 7) != addr[7]) {
Serial.println("CRC is not valid!");
return -1000;
}

if ( addr[0] != 0x10 && addr[0] != 0x28) {
Serial.print("Device is not recognized");
return -1000;
}

ds.reset();
ds.select(addr);
ds.write(0x44,1); // start conversion, with parasite power on at the end

byte present = ds.reset();
ds.select(addr);
ds.write(0xBE); // Read Scratchpad

for (int i = 0; i < 9; i++) { // we need 9 bytes data[i] = ds.read(); } ds.reset_search(); byte MSB = data[1]; byte LSB = data[0]; float tempRead = ((MSB << 8) | LSB); //using two's compliment float TemperatureSum = tempRead / 16; return TemperatureSum; }

To work with Arduino sensor you need to connect OneWire library using directive #include.

arduino_ds18b20

In the Arduino IDE open the Tools / Serial Monitor

ds18b20_serial




Оставить ответ

Обязательные поля помечены*

Этот сайт использует Akismet для борьбы со спамом. Узнайте как обрабатываются ваши данные комментариев.